Barnett Engineering ProTalk LINK, Руководство по эксплуатации

Страница: 51 / 81

SPECIFICATIONS PAGE 47
19200
38400
57600
115200
PLC Ethernet Network:
IP address: set by system administrator
Subnet mask: set by system administrator
Default gateway: set by system administrator
Modbus/TCP
Port Number: set by system administrator
Email/Web Server Ethernet Network:
IP address: set by system administrator
Subnet mask: set by system administrator
Default gateway: set by system administrator
DNS server: set by system administrator
Web Server:
Username: set by system administrator
Password: set by system administrator
Port Number: set by system administrator
Email server:
Server Address: set by system administrator
Port Number: set by system administrator
Block
Addressing:
Protocol
Each block, consisting of 16 points, is assigned a
protocol and a PLC to communicate with. The
protocol selected can be any of the always available
Ethernet protocols or either of the previously
configured protocols assigned to the RS232 or
RS485 ports.
Data Type
Type defines the data type for the 16 registers in a
block. For a PLC location Type can be bit, analog,
or for some protocols, a bit array. For blocks that are
located on a Link module, Type will be defined by
the hardware in that module.
Unit ID / Station ID
Where the protocol requires, each block is assigned a
Unit ID or Station ID which is the address of the
PLC. In slave mode all of these values will be the
same and is configured in the PLC Comm Settings
section. In master mode, each block can be assigned
its own value to allow communications with multiple
PLCs.