Barnes BARNES 4DSE-HL Series, Инструкция по установке и эксплуатации

Страница: 7 / 32

7
C-4.3) Moisture Sensors:
A normally open (N/O) detector is installed in the pump seal
chamber which will detect any moisture present. It is recom-
mended that this detector be connected in series to an alarm
device or the motor starter coil to alert the operator that a
moisture detect has occurred. In the event of a moisture
detect, check the individual moisture sensor probe leads for
continuity, ( ∞ resistance = no moisture ) and the junction
box/control box for moisture content. The above situations
may induce a false signal in the moisture detecting circuit. If
none of the above test prove conclusive, the pump(s) should
be pulled and the source of the failure identifi ed and repaired.
IF A MOISTURE DETECT HAS OCCURRED SCHEDULE
MAINTENANCE AS SOON AS POSSIBLE.
TEMPERATURE SENSOR ELECTRICAL RATINGS
Volts Continuous
Amperes
Inrush
Amperes
110-120 3.00 30.0
220-240 1.50 15.0
440-480 0.75 7.5
600 0.60 6.0
C-4.4) Wire Size:
Consult a qualifi ed electrician for proper wire size if additional
power cable is required. See table for electrical information.
MODEL
NO
HP VOLT PH RPM
(Nom)
NEMA
START
CODE
FULL
LOAD
AMPS
LOCKED
ROTOR
AMPS
CORD
SIZE
CODE
TYPE
CORD
O.D.
± .02 (.5)
in (mm)
WINDING
RESISTANCE
MAIN -- START
4DSE3096L 3 200-230 3 1150 C/G 10.6/9.2 51.3/64.0 10/4 SOW 0.75 1.24
4DSE3046L 3 460 3 1150 F 4.6 29.5 10/4 SOW 0.75 4.96
4DSE3056L 3 575 3 1150 F 3.6 23.6 10/4 SOW 0.75 ----
4DSE5096L 5 200-230 3 1150 B/E 15.6/13.6 74.8/86.0 10/4 SOW 0.75 0.86
4DSE5046L 5 460 3 1150 E 6.8 43.0 10/4 SOW 0.75 3.44
4DSE5056L 5 575 3 1150 E 5.4 34.4 10/4 SOW 0.75 -----
4DSE7596L 7.5 200-230 3 1150 B/D 24.4/21.3 107.8/124 10/4 SOW 0.75 0.75
4DSE7546L 7.5 460 3 1150 D 10.6 62.0 10/4 SOW 0.75 2.99
4DSE7556L 7.5 575 3 1150 D 8.48 49.6 10/4 SOW 0.75 ----
4DSE3024L 3 230 1 1750 A 24.0 59.0 10/4 SOW 0.75 0.30 -- 1.20
4DSE3064L 3 200 3 1750 C 11.5 48.6 10/4 SOW 0.75 0.71
4DSE3034L 3 230 3 1750 E 9.4 56.0 10/4 SOW 0.75 1.43
4DSE3044L 3 460 3 1750 E 4.7 28.0 10/4 SOW 0.75 5.71
4DSE3054L 3 575 3 1750 E 3.8 22.4 10/4 SOW 0.75 ----
4DSE5024L 5 230 1 1750 A 35.0 96.0 8/4 SOW 0.83 0.5 -- 2.20
4DSE5064L 5 200 3 1750 B 15.0 69.5 10/4 SOW 0.75 0.43
4DSE5034L 5 230 3 1750 D 13.0 80.0 10/4 SOW 0.75 0.71
4DSE5044L 5 460 3 1750 D 6.5 40.0 10/4 SOW 0.75 2.85
4DSE5054L 5 575 3 1750 D 5.2 32.0 10/4 SOW 0.75 ----
4DSE7564L 7.5 200 3 1750 B 24.6 109.5 10/4 SOW 0.75 0.35
4DSE7534L 7.5 230 3 1750 D 21.4 126.0 10/4 SOW 0.75 0.43
4DSE7544L 7.5 460 3 1750 D 10.7 63.0 10/4 SOW 0.75 1.72
4DSE7554L 7.5 575 3 1750 D 8.6 50.4 10/4 SOW 0.75 ----
4DSE5024HL 5 230 1 1750 A 34.0 96.0 8/4 SOW 0.83 0.5 -- 2.20
4DSE5034HL 5 230 3 1750 D 20.0 80.0 10/4 SOW 0.75 0.71
4DSE5044HL 5 460 3 1750 D 10.0 40.0 10/4 SOW 0.75 2.85
4DSE5054HL 5 575 3 1750 D 8.0 32.0 10/4 SOW 0.75 ----
4DSE7534HL 7.5 230 3 1750 D 26.0 126.0 10/4 SOW 0.75 0.43
4DSE7544HL 7.5 460 3 1750 D 13.0 63.0 10/4 SOW 0.75 1.72
4DSE7554HL 7.5 575 3 1750 D 10.4 50.4 10/4 SOW 0.75 ----
4DSE10034HL 10 230 3 1750 D 32.2 160.0 8/4 SOW 0.83 0.35
4DSE10044HL 10 460 3 1750 D 16.1 80.0 8/4 SOW 0.83 1.45
4DSE10054HL 10 575 3 1750 D 12.9 64.0 8/4 SOW 0.83 ----
Winding Resistance ± 5%, measured from terminal block. Pump rated for operation at ± 10% voltage at motor.
Moisture & Temperature sensor cord for ALL models is 18/5 SOW, 0.476 (12) ± .02 O.D.