Barnes BARNES 4DSE-HL Series, Инструкция по установке и эксплуатации

Страница: 4 / 32

4
PUMP DISCHARGE ....... 4” 125lb, Horizontal
PUMP SUCTION ............ 4” 125lb, Flange w/ 3.75” (95mm)
Cleanout
LIQUID TEMPERATURE . 104°F (40°C) Continuous
BASE ELBOW ............... Cast Iron ASTM A-48, Class 30
MOTOR HOUSING ........ Cast Iron ASTM A-48, Class 30
VOLUTE ......................... Cast Iron ASTM A-48, Class 30
SEAL PLATE ................. Cast Iron ASTM A-48, Class 30
IMPELLER:
Design ........... 2 Vane, Open with Pump out vanes
on Back side. Dynamically
balanced, ISO G6.3
Material ........ Cast Iron ASTM A-48, Class 30
SHAFT ............................ 416 Stainless Steel
SQUARE RINGS ............ Buna-N
DIAPHRAGM ................. Buna-N
HARDWARE .................. 300 Series Stainless Steel
PAINT ............................. Air dry enamel, top coat
SEAL Design .......... Double Mechanical in oil fi lled
pressure equalized reservoir
Material ........ Rotating Faces - Carbon
Stationary Faces - Ceramic
Elastomer - Buna-N
Hardware - 300 series stainless steel
CORD ENTRY ................ 40 Ft. (12.1m) Cord, Epoxy sealed
housing with secondary pressure
grommet for sealing and strain relief
SPEED ........................... 1150 & 1750 RPM, 60Hz (nominal)
UPPER BEARING:
Design .......... Single Row, Ball, Oil Lubricated
Load ............. Radial
LOWER BEARING:
Design .......... Double Row, Ball, Oil Lubricated
Load ............. Radial & Thrust
MOTOR: Design .......... NEMA L, Single phase,
NEMA B, Three Phase Torque Curve,
Oil Filled, Squirrel Cage Induction
Insulation ...... Class F
SINGLE PHASE ............. Capacitor Start/Capacitor Run.
Requires BARNES Starter/Panel
Which includes capacitors and
overload protection
THREE PHASE .............. 200-240/480 is Tri voltage motor.
Requires overload protection
to be included in control panel
MOISTURE SENSOR .... N/O, Requires relay in control panel
TEMP. SENSOR ............. N/C, Requires relay in control panel
OPTIONAL EQUIPMENT .. Seal Material, Impeller Trims,
Additional Cord,
SECTION: A - PUMP SPECIFICATIONS:
4DSE-L Pump Models
inches
(mm)