11
InstructionsForUse
Warnings(continued)
Warning:
Do not attempt to sterilize the Site~Rite 5 scanner or probes with ethylene oxide or
heat sterilization methods. Damage to the equipment may occur.
Warning:
Always properly dispose of dead battery packs in accordance with local regulations.
Improper disposal may present an enviromental hazard.
Warning:
Only qualified personnel should attempt to service this equipment. The Site~Rite 5
contains static sensitive components and circuits. Failure to observe proper static
control procedures may result in damage to the system.
Warning:
The following actions void the warranty of the Site~Rite 5 System.
• Opening or servicing the scanner or the probe housing.
• Removal of system labels by anyone other than by Bard Access Systems
authorized service personnel.
• Opening or servicing the battery pack or the combination A/C adapter and battery
charger by anyone other than Bard Access Systems authorized service personnel.
• Connecting the Site~Rite 5 scanner to any power source other than the Site~Rite 5
combination A/C adapter and battery pack.
• Connecting the Site~Rite 5 scanner to any A/C adapter other than the one
provided with the scanner.
• Connecting the Site~Rite 5 system to any unauthorized accessory.
Warning:
Inspect A/C adapter and battery cord for damage. If any of the prongs are damaged,
use battery power until replacement cord is obtained.
Warning:
Verify that all accessories attached to the system comply to 60601 safety standards.
Non-compliance may result in increased patient risk.
Warning:
Use only IEC or ISO approved safety devices outside the patient environment. Failure
to do so may damage the equipment.
Warning:
Equipment that relies on basic insulation only shall not be used with this system.
Failure to comply could result in increased patient risk.
Warning:
Maximum shelf load on the VAD bedside roll stand is 22 lbs. Exceeding this weight may
damage the roll stand.