Barco R9841020 Cine VERSUM Master, Руководство по установке

Страница: 86 / 161

12. Image Projection after Powering Up
How starting the image projection (Case C)
1. Press the ADJ or ENTER key (On InfraRed Remote Control, page 30). Menu on graphical display changes as follows –menu 12-1.
2. Press the cursor keys ↑ or ↓ to select item ’Power Up’ (arrow in front of item).
3. Press ENTER to confirm. The Cine VERSUM Master starts up, indicated by the message ’Power up’ in the display (menu 12-2).
The Cine VERSUM Master starts operation mode and starts on its turn image projection on the linked displays of the source
displayed when powering down the system before. The file of the selected source is added to the menu (left-bottom)menu 12-3).
12.3 Lamp Mode Set Up for Cine VERSUM 120 Only
Overview
• Lamp Mode Set Up Single/Dual (Image Settings menu)
• Lamp Mode Set Up Economic/Normal (Image Settings menu)
• Lamp mode/Power set up in Display Settings menu
About Lamp Mode for Cine VERSUM 120
The Cine VERSUM 120 is equipped with a dual lamp unit. This lamp unit can be programmed to work in a single or a dual lamp
mode as well as boosted in power from 200 W (Economic) to 250 W (Normal).
When a lamp fails in the dual lamp mode, the projector goes on with projection on the remaining lamp.
When programming Single mode, then the least used lamp will be ignited.
Lamp ’mode’ and ’power’ can be set up in the IMAGE SETTINGS and in the DISPLAY SETTINGS menu. Both
set ups overrule each other, except when forced lamp 1 or 2 has been chosen in the LAMP MODE menu.
12.3.1 Lamp Mode Set Up Single/Dual (Image Settings menu)
When forced lamp 1 or 2 has been set up, then, item
LAMP MODE
in the Image Settings menu is replaced by
non-active ’Forced lamp 1 or 2’ item.
How to set up:
1. Enter the MAIN menu and scroll through the sub menus, using the jog dial or the Remote Control until the Image Settings menu
for the Cine VERSUM 120 is displayed. (image 12-1)
2. Select menu item
LAMP MODE
and enter the lamp mode ’Single’ or ’Dual’ by pressing the jog dial or the ENTER key on the
Remote Control.
Note: Results of lamp switching from Single to Dual will take some time due to the ignition time of the second lamp.
3. Leaving the GUI, use the
BACK
item in the menu or press EXIT key on the Remote Control.
CineVERSUM
Image settings
Advanced Settings
Installation
Service
1 NO MODULE
2 NO MODULE
3 VIDEO [VIDEO]
4 NO MODULE
5 NO MODULE
6 NO MODULE
7 RGB-YUV [RGB]
8 NO MODULE
Shut Down
Back
Image Settings
Master
Brightness
Contrast
Saturation
Tint
Display
Back
Display List
1 CV50 On
2 CV80 On
3 CV120 On
Back
[Single/Dual]
Cine VERSUM r01
CV120
Main Menu/
Image Settings
/
Display
/
CV80 or CV120
/
Lamp Power
If the CV120 is the only display in the link
Image Settings
Display
Brightness
Contrast
Gamma
Color Temperature
Primaries:[Projector]
Lamp mode: [Single]
Lamp Power:[Normal]
Master
Back
Image 12-1
Menu item Lamp Mode
82 R5976468 CINE VERSUM SYSTEM 03112003