Barco R9040014, Руководство по установке

Страница: 28 / 48

Source Connections
6-4 5976257 BARCOREALITY 909 16032001
Connecting a RGB Analog source to Port 3
Connect a RGB Analog signal via an interface (e.g. RGB 120MHz interface, part number 98 26570) to Port 3: RGB analog input
with automatic sync detection (Separate H and V sync inputs, with composite sync input or with sync signals on green).
ON OFF
POWER / MAINS
80 0 per ip her als
R G B
Comp-/H-SyncV-Sync
COMM. POR T PORT 3
P O RT 4 / 5
V-nom
I-nom
Freq
See in stallation instruction s befo re con nectin g to th e su pply.
Voir la no tice d'installation av ant d e raccorder au réseau .
120/230 V
7/5 Amp
50/60 Hz
S-VIDEO OFF - ON
75 Ohm
VIDEO
green : operation
red : standby
PORT 2
POR T 1
OFF - ON
75 Ohm
PROJ ECTOR MOD E
i n ver. 75 ohm term.
Th is d ev i ce c ompl i es wi th par t 1 5 of
the FCC r ul es . Oper ati on i s sub j e ct to
fo l lo w i n g t w o co n d i t io n s (1) . T h is
de v ic e may n ot c aus e har mful i nter -
fere nce , an d (2) thi s de v ic e mus t
ac cep t an y i nterfer en ce re ce iv e d
i ncl ud in g in te rfer enc e th at m ay ca use
un des ir ed o per atio n"
RGB 120MHz interface
Settings on module level
In the case of this second RGB input there are three different settings:
1. 75 Ω Termination resistor
2. Blue in Green switch
3. Force Negative Sync switch
When changing a switch position or removing a resistor, turn off the projector and unplug the power cord from the wall outlet.
Pin assignment for the D9 (male) connector:
1 not connected
2 ground RGBS
3 RED
4 GREEN
5 BLUE
6 ground RGBS
7 ground RGBS
8 Horizontal /composite sync
9 Vertical sync
S2 Blue in Green (ON=yes)
S1 Force negative Sync
(ON=yes)
R1
(red)
R101
Vsync R81
Hsync R41
(Blue)
R21
(Green)