Barco - NSL-4601 - User manual ______________________________________________________ 19
Installation
4.4.4
Monitor ID DIP switch settings
The address of a monitor (monitor ID) is a double (x, y) where x represents the
horizontal position (column) and y the vertical position (row) of the monitor in
the wall. The top left monitor (seen from front) has the address (0,0):
Numbering starts with zero and goes from left to right and from top to bottom.
The address is set in binary code via two 4-dip switches, one for x and one for y.
These dip switches are at the rear side of the monitor, see schematics of
interfaces.
Below an example of 4 sets is given:
Figure 6: Monitor ID DIP switch settings
SET 3
SET 4
SET 2
SET 1
[ X : 0 ]
[ X : 1 ]
[ X : 0 ]
[ X : 1 ]
[ Y : 0 ]
[ Y : 1 ]
[ Y : 0 ]
[ Y : 1 ]
SET Monitor ID
[ X : SET ID X ]
[ Y : SET ID Y ]
1
2
3
1
2
3
Monitor ID: the DIP switch is used to set the monitor ID via its X/Y coordinates
The X, Y coordinates need to be set to binary code
This is an example of the monitor ID setting for a set of 4 monitors
