Barco Njord, Руководство по установке

Страница: 21 / 232

21 R5913593 /01 Njord
2.2 Installation process
Physical installation process overview
1. Install the projector in the desired position taking following points into account:
• Ensure that the physical setup of projector complies with all safety requirements such as the hazard
distance restriction zone etc. See safety chapter
“ HD in function of modifying optics ” , page 209.
• Projector configuration:
-
In case of a standing installation:
◦ Use a solid pedestal to place a single NJORD projector on (with or without rigging frame)
◦ Use a solid pedestal and NJORD rigging frames for stacking the NJORD projectors up to
maximum 3 units high.
- In case of a hanging installation:
◦ Use the NJORD rigging frames to suspend up to maximum 2 stacked NJORD projectors (Table
Mount or Ceiling Mount).
◦ Use a NJORD rigging frame to hang one NJORD projector in portrait (wall mount)
Note: For detailed instructions on how to use (install, suspend, stack, adjust, ...) the NJORD
rigging frame see separate documentation of the NJORD rigging frame.
Note: Ceiling mount and wall mount of a single NJORD projector can be realized without
NJORD rigging frame but then a 3rd party interface needs to be added between the projector
and the surface to attach the projector on. See
“ Wall or ceiling mount without rigging frame ” ,
page 54 for more details.
2. Installation of the lens. For detailed instructions see “ Lens installation ” , page 45.
Caution: Instal the lens safety cable in case the projector is mounted above people. For detailed
instructions see documentation of the lens safety cable. For ordering info see Barco website.
3. Electrical connection with the power net. See chapter “ Connecting the projector with the power net ” , page
44.
4. Install the batteries of the Remote Control Unit (RCU). See chapter “ Remote control, battery installation ” ,
page 42.
5. Installation of the Projector Toolset on local laptop. Download and install the latest version from the Barco
website. See chapter
“ Download Projector Toolset ” , page 39.
6. Switch on the projector and start image projection. See user guide of the projector for details on how to
operate the projector. Following options are possible to control the projector:
• using the RCU
-
Remotely. Ensure that the RCU address matches the projector individual address for the IR
receivers. For details see chapters:
◦ “ Displaying and Programming addresses into the RCU ” , page 49.
◦ “ Setting the projector addresses ” , page 51.
- Hard wired. RCU with XLR cable connected. See “ Using the XLR connector of the RCU ” , page 50
• using the Local Keypad.
• using Projector Toolset. See manual of the Projector Toolset.
7. Alignment of the projected image with the screen. Activate an internal test pattern to focus, zoom and shift
the lens until the projected image is aligned with the screen. Use for that the:
• Focus, Zoom and Shift buttons of the RCU.
• Lens adjustment button of the Local Keypad. For detailed instructions see user guide of the projector.
• Projector Toolset control software. For detailed instructions see user guide of Projector Toolset.
To level the projector with the screen adjust the feed of the projector in case of a table mount installation
(see
“ Alignment of a table mounted projector ” , page 52), or adjust the rotation of the rigging frame in case
of a suspended installation (see “ Alignment of projector in the rigging frame ” , page 53).
8. If needed change the projector orientation (e.g. Front/Table, Front/Ceiling, Rear/Table, Rear Ceiling). See
user guide of the projector for the software settings of the projector orientation.
Installation process