Barco IEX Series, Инструкция по установке и эксплуатации

Страница: 9 / 80

9 R5915190 /01 IEX series
fire. Simulated single fault condition testing ensures the safety of the equipment to the user even when the
equipment's normal operation fails.
Product care
Structural & mounting components should be kept dry, clean, lubricated (only if recommended), coated
properly, and otherwise maintained in a manner consistent with part design. Barco products must be used in a
manner consistent with their design and inspected on a routine basis for security, wear, deformation, corrosion
and any other circumstances that may affect the load handling capability of the part.
Barco recommends inspections at regular intervals for all installations and increasing in frequency for more
critical installations. If a part is found to have damage, which may cause a decrease in load capability, the part
must be removed for service or replaced immediately.
Under no circumstances are Barco parts repairable by anyone other than Barco.
1.2 Important safety instructions
Instructions:
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Clean only with materials or chemicals that are inert, nonabrasive, noncorrosive and non-marking. Consult
the manufacturer for further advice should any doubts exist regarding any cleaning procedure.
• Do not block ventilation openings. Install in accordance with the manufacturers instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
• Do not defeat the safety purpose of the polarized or grounding type plugs/sockets. If the provided sockets/
plugs are damaged then replacement of the defective parts must be undertaken immediately.
• Protect the power/data cords from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus. Replace damaged power/data cords
immediately.
• Only use attachments/accessories specified by the manufacturer.
• Disconnect the power to this apparatus during lightning storms or provide suitable additional lightning
protection. Unplug this apparatus when unused for long period of time.
• Refer all servicing to qualified service technicians/personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is damaged, the apparatus does not operate
normally, or has been dropped.
• Use only with systems or peripherals specified by the manufacturer, or sold with the apparatus. Use
caution during lifting/moving or transporting to avoid damage by possible tipping.
• Do not use damaged LED tiles. Replace damaged parts immediately. Ensure that the spring of each
locking mechanism (latch) is functioning properly. If not, replace immediately.
1.3 Important warnings
Important warnings:
Risk of electric shock:
Do not open. To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts
inside. Refer servicing to qualified service personnel.
Maximum and minimum ambient temperature:
The maximum ambient temperature for the LED wall is 40°C (104°F), the minimum temperature is -10°C (14°
F).
Low Voltage Surge Protection Device required
Due to the damaging effects of lightning, utility switching and switching electric motors of other users on the
mains, this product needs to be protected by means of a Surge Protection Device. If this product is connected
Safety