Barco DP-1200, Руководство по установке

Страница: 28 / 134

3. Physical Installation
3.4 Power loop through to the projector electronics
This procedure explains how to provide the projector electronics with power in case no UPS unit is used.
Note that the projector is by default con
fi gured for use without UPS. So, the short power link cable is already
installed.
INLET/OUTLET fi xation accessories
The plugs of the power cable which are inserted in the power INLET or OUTLET socket of the projector have to be secured. The
projector is equipped with
fi xation accessories as illustrated below.
1
2
3
4
7
8
5
6
Image 3-10
1 Short power link cable (loop through).
2 Spare spacers with different length.
3 Thumbscrews.
4 Long spacers.
5 Fixation bracket for the female plug (OUTLET).
6 Fixation bracket for the male plug (INLET).
7 Male plug.
8 Female plug.
Necessary parts
Short power link cable with plug type C13/C14.
How to loop through the power to the projector electronics?
1. Make sure that a long spacer (reference 1) is mounted above and below each power socket (reference 2 &3).
2. Plug in the short power cable (reference 4) which was delivered with the projector.
Warning: Always use the Barco short power cable which is delivered with the projector.
3. Secure both plugs of the short power cable with a fi xation plate. Use two thumbscrews (reference 5) per fi xation plate. Note
that the smallest fi xation plate (reference 7) has to be used upon the upper socket (INLET, reference 2). The large fi xation plate
(reference 6), which holds the spare spacers, has to be mounted upon the lower socket (OUTLET, reference 3).
24 R59770242 DP-1200 06/01/2009