Barco Coronis 3MP, Инструкция по установке и эксплуатации

Страница: 77 / 80

77
Setting the resolution of your C
ORONIS
3MP display
Note:
In order to set the resolution of your C
ORONIS
3MP you must
be logged in using an account with administrator privileges.
1. Open the “
Windows Display Control Panel
” by one of the
two methods below:
a) Start > Settings > Control Panel > Display
or
b) Open the
“Display Properties Control Panel”
by right
clicking in an empty area on the desktop, then select
“Properties”
.
2. Click on the
“Settings”
tab.
3. Select the
rectangle
that represents the Barco Coronis
display whose settings you wish to change.
Note:
If you are using the VGA capabilities of your
BarcoMed C
ORONIS
display controller, the resolution for the first
display may be set to a VGA resolution of “640 x 480” pixels with
16 colors and a default refresh rate. If your BarcoMed C
ORONIS
controller is not running VGA, the display may not be enabled
yet. To enable the display, check the “Extend my Windows
desktop onto this monitor”
checkbox
, but do
NOT
click the
“Apply”
button at this time.
If you installed your B
ARCO
C
ORONIS
Display System drivers in
SingleView
mode (default for Windows 2000) there will be
one rectangle for the virtual display representing the two
heads controlled by each BarcoMed C
ORONIS
display
controller.
If you installed your B
ARCO
C
ORONIS
Display System drivers in
DualView
mode (default for Windows XP) there will be a
rectangle representing each head controlled by each
BarcoMed C
ORONIS
display controller. This will be true even if
you have only one display connected to your
BarcoMed C
ORONIS
controller. Both displays of a display
controller cannot be enabled at the same time unless their
display properties match. If necessary detach the second