Barco Coronis 3MP, Инструкция по установке и эксплуатации

Страница: 28 / 80

Installation
28
To connect the power:
Figure 10
1. Connect the output of the 12V DC power supply to the DC
input (7) of the display.
2. Connect one end of the proper power cable to the AC input
of the 12V DC power supply.
3. Connect the other end of the power cord to a grounded
power outlet.
4. Route the cable so that it enters the connector compartment
at the place where the cover is bulged.
Routing the signal cables
After connecting all cables, fix them in the cable tie at the rear of
the connector compartment. Bind the cables together above and
under the foot, by means of the 2 velcro strips included in the
package.
After fixing the cables, put the connector compartment cover
back in place. Pay attention that the signal cables are positioned
under the bulge in the cover.
Next, fix the cables in the plastic clamps on the foot. At last, put
the foot cover back in place.
To put the foot cover in place:
Connect to DC input
of the display Connect one end of
power cable