Barco Coronis 3MP, Инструкция по установке и эксплуатации

Страница: 16 / 80

BarcoMed C
ORONIS
display controller installation
16
Figure 2: VGA Jumper Enlarged View
Using the VGA capabilities of the BarcoMed C
ORONIS
Prior to installing the BarcoMed C
ORONIS
, decide if you are going
to use its on-board VGA capabilities. If you are, check the setting
of the Jumper at J-1 on the display controller (see figure 2 VGA
Jumper Enlarged View). By default, VGA should be enabled, on
the top two pins.
NOTE:
To use multiple BarcoMed C
ORONIS
display controllers in a
single host with VGA enabled, you need to enable VGA on only
ONE of the BarcoMed C
ORONIS
display controllers and disable VGA
on ALL other BarcoMed display controllers.
Examples of PCI slots
Although the BarcoMed C
ORONIS
controller is a 64-bit board, it
may be installed in either a 64-bit or 32-bit PCI slot. However,
installing it in a 32-bit PCI slot will result in a decrease in
performance. Figure Figure 3 illustrates the types of slots so that
you can correctly identify which one to use for the
BarcoMed C
ORONIS
.