![background image](http://html1.mh-extra.com/html/barco/barcovision-8100/barcovision-8100_owners-manual_473915059.webp)
5975617 BARCOVISION 8100 150197
CONTROLLING
CO
NTR
O
LLI
NG
5975617 BARCOVISION 8100 150197
CONTROLLING
CO
NTR
O
LLI
NG
8-3
8-3
Plug one end of the remote cable in the connector on the bottom of the RCU and the
second side in the connector in the front panel of the BARCOVISION 8100 labelled
'REMOTE'.
c) Point the front of the RCU direct at one of the IR sensors of the projector.
When using the wireless remote control, make sure you are within the effective
operating distance (30m, 100ft in a straight line). The remote control unit will not
function properly if strong light strikes the sensor window or if there are obstacles
between the remote control unit and the projector IR sensor.
0
9
7
8
6
5
4
3
2
1
RCU
Ceiling
Front of projector
IR sensor
0
9
7
8
6
5
4
3
2
1
RCU
Rear of projector
IR sensor
Table
0
I
D IA
G NO
STI
C S
C O
D E
PROJECTOR ADDRESS
a. hardware set up of the projector address.
Every projector requires an individual address between 0 and 255 which is set with
hardware DIP switches. To change that address, it is necessary to first open the top
cover (see Gaining access to the DIP switches under Connecting to a computer.).
8 DIP switches (S1) are provided on the CPU module. Each DIP switch has its own
decimal value (ON='1', OFF = '0'). The summary of the values associated to those
DIP switches gives the address
Plug one end of the remote cable in the connector on the bottom of the RCU and the
second side in the connector in the front panel of the BARCOVISION 8100 labelled
'REMOTE'.
c) Point the front of the RCU direct at one of the IR sensors of the projector.
When using the wireless remote control, make sure you are within the effective
operating distance (30m, 100ft in a straight line). The remote control unit will not
function properly if strong light strikes the sensor window or if there are obstacles
between the remote control unit and the projector IR sensor.
0
9
7
8
6
5
4
3
2
1
RCU
Ceiling
Front of projector
IR sensor
0
9
7
8
6
5
4
3
2
1
RCU
Rear of projector
IR sensor
Table
0
I
D IA
G NO
STI
C S
C O
D E
PROJECTOR ADDRESS
a. hardware set up of the projector address.
Every projector requires an individual address between 0 and 255 which is set with
hardware DIP switches. To change that address, it is necessary to first open the top
cover (see Gaining access to the DIP switches under Connecting to a computer.).
8 DIP switches (S1) are provided on the CPU module. Each DIP switch has its own
decimal value (ON='1', OFF = '0'). The summary of the values associated to those
DIP switches gives the address