Barco Athena, Руководство по установке

Страница: 99 / 184

R5906790 /04 Athena 99
10.2 Switching the Athena OFF
How to switch the Athena OFF?
1. Press the Standby button on the Local Keypad or use the Communicator Touch Panel to switch the projector
from Lamp ON mode to Standby mode. As a result the lamp turns off while the fans keep turning to cool down
the projector.
2. Allow the projector to cool down for 5 minutes minimum or until the speed of the fans decreases.
3. Switch the projector OFF with the power switch.
Tip: Make sure no lens motors are running while switching off the projector. Wait for lens positioning to
complete.
1
5min
Image 10-2
How to put the projector into Sleep mode?
1. Check if the lamp is switched off. If not, press the Standby button on the Local Keypad or use the
Communicator to switch the lamp off. The backlight color of the Standby button is red when the lamp is
switched off.
Note: To put the projector into Sleep the projector must be in Standby mode (in other words the lamp
must be off). If the lamp is ignited he Sleep button is disabled notwithstanding the backlight color of
the Sleep button is green.
2. Press the SLEEP button on the Local Keypad for three seconds or use the Communicator to put the projector
into Sleep mode.
As a result the projector immediately shuts down the electronics but when the lamp is still too hot the projector
will finish the after cooling cycle and then finally go to sleep. The backlight color of the Sleep button is white in
Sleep mode even when the projector is finishing the after cooling cycle.
Note: Pressing the Sleep button before the after cooling cycle has finished, will re-start the projector in
a normal way.
Starting up