35
7 - MAINTENANCE
SECTION 7 - MAINTENANCE
To sharpen the blades, follow the instructions in section 7.2.7.
If the screws are loose, replace the knife fastening screws on both sides If the knives
are deformed, replace the knives and fastening screws immediately If the blade holder is
deformed, replace it with a new holder.
DANGER:
Do not try to use the machine if the blade is not in good working order:
Structural failure of the blades or their fastening systems can lead to serious and
even fatal accidents
7.2 MAINTENANCE AND ADJUSTMENT
7.2.1 MAINTENANCE AND ADJUSTMENT
See the Periodic Maintenance table on the next page.
7.2.2 Maintenance schedule and lubrication program
For the engine oil, always observe the operating instructions of the engine manufactu-
rer. The first oil change must take place after the first 50 hours of operation, which is the
engine break-in time. This change removes the floating metallic particles created by the
rotating parts. Let the engine run for a few minutes to warm up.
Before you start checking the level or changing the oil, carefully clean the area around
the oil cap to prevent foreign bodies from getting into the housing.
Remove the plug with the dipstick (A) and remove the drain plug (C) if you do not have
an oil suction pump. Collect the used oil in a pan. Put exhausted oil in a suitable con-
tainer for disposal. Close the drain plug and add fresh oil to the correct level from the
screw (A). For the general temperature, SAE 10W-30 is recommended.
Other viscosities shown in the table can be used if the average temperature in your area
is within the stated range.
The engine oil type is (Agip Rotra MP) (SAE 10W / 30). The oil quantity is 2.2 Lt.
Check the oil level as described in chap. 7.1.1.
-20 0 20 40 60 80
100°F
-30 -20 -10 0
10 20 30
40°C
Ambient temperature
20W -40 , 20W -50
10W - 40
10W - 30
Fig. 27
A
C
Содержание TracMow 95 EVO
Страница 6: ...5 NOTES...
