Barbieri TracMow 95 EVO, Руководство оператора

Страница: 22 / 48

This section explains the various devices in the machine and shows the dangers or misu-
se that must be avoided. We recommend that you carefully read and become familiar with
the procedures that will result in correct use of the machine in order to obtain maximum
performance while minimizing intrinsic risks.
Beacon-net
The flashing light provides various information about the status of the machine. It will be
useful to learn the key information presented in the diagram below.
5.1 CONNECTION OF THE RADIO CONTROL
Turn the ignition key to “ON”. An acoustic signal and the continuous red light from Bea-
con-net warn that the radio control is not connected.
To connect the radio control, press the green button A (Fig. 10) on the left and wait for the
green light (H) and the blue light (L) to start flashing. When both lamps flash, press the
green button A (Fig. 10) again for one second and then release it. Both lights stop flashing
and the acoustic signal stops and the light turns green flashing: the radio control is con -
nected. In the event of an error, repeat the process.
5.2 ENGINE START (fig.10 - 11)
Move the throttle lever up (Fig. 10 (Q)) to the maximum.
Keep pressed the button (A) and then press the button (B) (Fig. 10)
until the engine starts.
Lower the throttle control to idle speed and allow the engine to warm
up. The engine speed can now be set and the value is displayed by
the bar chart (Fig. 12 (bottom-right)).
21
5-SAFE USE
SECTION 5 - INSTRUCTIONS FOR A SAFE USE
Fig. 11b
BeaconNet
Fig. 11