barbas Evolux 100-45, Руководство по установке и обслуживанию

Страница: 17 / 48

55.2 Preparation for installation
• The optional convection ventilator and optional Opti-Air system both need a 230 VAC
grounded electrical power supply near the installation location.
Warning:
• The electrical connections must be grounded.
• The electrical connections must be made by a certified electrician.
• Make sure the electrical connections can always be accessed.
• Make sure the door of the appliance opens and closes correctly.
• Make sure the baffles are in the correct position
• Make sure the control lever can move freely to left and to right.
• Make sure the ashtray is empty.
• If applicable, make sure the fire screen moves up and down correctly.
5.3 Installation procedure
Do all the procedures in this section. Optional procedures are indicated with (optional).
5.3.1 Install the appliance
Caution: Do not lift the appliance with any kind of forklift. This will cause
damage to the underside of the appliance. Only use the carrying tubes to
move the appliance.
Caution: Do not hold the chain case to move the appliance. This can damage
the door lift mechanism.
Caution: If the appliance is installed against a flammable rear and/or side wall,
precautions must be taken to prevent accidental fire. Refer to
5.3.7
for a
description of suitable precautions.
1. Install the carrying tubes (Ø38 mm) together with the bracket on the appliance or put
the carrying tubes in the optional adjustable height frames. You can use the carrying
tubes to move the appliance.
Note: The carrying tubes are not included with the appliance.
2. Install the appliance. Make sure the distance between the appliance and rear wall is
approximately 10 cm minimum.
Installation
Evolux 100-45 17