Barazza B_AMBIENT, Руководство по установке

Страница: 41 / 128

29
AUTOMATIC CONTROL OF GREASE AND CARBON FILTER
the electronic controls with led points allow automatic control of the grease filters and
carbon filters (only in case the hood is used in filtering version) so that the user does not
have to remember when maintenance was last carried out.
When the grease filters require cleaning, an acoustic
signal is issued for some seconds and the led point above the push button keeps on on
flashing.
When the carbon filters need replacing, an acoustic
signal is issued for some seconds and the led point above the push button keeps on
flashing.
TO PUT THE GREASE AND CARBON FILTERS CONTROL BACK TO ZERO. + and/or
+
To put the grease filter counter back to zero you must:
■
Stop the motor;
■
Press the push button twice in succession, until you hear the acoustic signal.
To confirm reset the led point stops flashing.
To put the carbon filter counter back to zero you must:
■
Stop the motor;
■
Press the push button twice in succession, until you hear the acoustic signal.
To confirm reset the led point stops flashing.
CHANGING OVER FROM SUCTION VERSION TO FILTERING VERSION. + +
The hood is delivered standard for suction.
If you wish to use the hood in filtering version do as follows:
■
disconnect hood from electricity and then reconnect this to electricity;
■
The led point of the push button will flash approximately for 10 seconds; during
this time press the push buttons for 3 times. Three acoustic signal are issued to
point out the new setting.
During the suction/filtering setting phase no function can be activated.
If the hood is used for suction use when connected to the plug you have the led on the
LIGHT push button
. Is flashing for 10 seconds.
If the hood is used for filtering use, when connected to the plug the led above the TIMER
push button
is flashing for 10 seconds.