BAQ dynaROCK II, Руководство пользователя

Страница: 22 / 46

OPERATION OF THE DEVICE
place, Vickers, Brinell, Shore and tensile strength without any decimal place. If
the measured value lies within the tolerance limits, a beep is emitted, otherwise
2 short tones.
6.2.3 Key layout of the measurement window
6.3 Statistics
If the measured value memory is switched on, the values of a series can be
evaluated statistically at all times. Even if the measured value memory is not
switched on, the hardness numbers are always temporarily stored until the
measurement window is closed. Thus a statistical evaluation of the measured
values can also be displayed with switched off measured value memory.
If the hardness scale or material is changed by key press in the measurement
window, the statistics are reset.
22
DIR Changes the impact direction
SCALE Changes the hardness scale. If the tolerance limits cannot be
converted into the new scale, they are automatically set to 0.
However, the values set-adjusted in the measuring parameters
are stored so that, in case of renewed changeover into a scale
in which the limits can be converted, these are again set to the
adjusted values.
In the system settings it can be determined whether the scale
should be changed automatically or a dialog should be opened
(see 9.4.2).
Deactivated if the measured value memory is switched on.
MAT Changes the material. If the currently selected hardness scale
is not defined for the new material, the hardness scale is
automatically reset to HL.
In the system settings it can be determined whether the
material should be changed automatically or a dialog should be
opened (see 9.4.3).
Deactivated if the measured value memory is switched on.
DEL Deletion of the last measured value
STAT Display of the statistics concerning the already measured
values