97654 v.7
31
Data logging saves (*CSV files) to any
Micro SD card (all classes) as ".CSV"
files at 0.1 sec intervals. Up to 100
parameters can be recorded at the
same time but as the number of
recorded parameters are increased,
the recording rate will decrease, so
only record the parameters you need.
Logged data will have 1 more
digit than displayed, i.e. MAP=15.1
is displayed, but MAP=15.13 will be
logged.
When viewing the
Gauge Screen
of the primary iDash 1.8, a green dot
at the top of the display will flash
indicating that the device is logging.
When logging is turned off, this dot will
not appear.
Only the primary iDash (gauge
plugged into the OBD-II port) will contain
the data log. If you have multiple iDash
gauges, only one of them needs to
be equipped with data logging. For
example, if you purchased your first
gauge without data logging you can
enable data logging by adding a data
equipped gauge as a secondary. All data
logging on iDash is referred to as Banks
parameter ID's or BID's
6.1 Change Parameters to
be Data Logged
All iDash 1.8 ship with a preconfigured
list of parameters set up for data
logging.
To remove parameters from being
recorded:
1.
Select
"Data Logging"
from the
main "
MENU
." See
Figure 6-1.
2.
Select "
Select Parameters.
"
3.
Select the individual parameter(s) to
be removed.
(See
Figure 6-2, A
) You
can multi select parameters in this list.
The non-highlighted parameters (See
Figure 6-2, C
) will not be recorded
and will be removed from the list once
you exit the screen.
4.
Or select "
CLEAR ALL BIDs
" to
remove all parameters.
See
Figure 6-2, B.
To set new vehicle parameters to
record:
1.
Select
"Data Logging"
from the
main "
MENU
."
2.
Select "
Select Parameters.
"
See
Figure 6-1.
SECTION: 6
DATA LOGGING
(IF EQUIPPED)
Figure 6-1 – Data Logging Menu
Figure 6-2
A
B
C
