B&R Automation PC 620, Руководство пользователя

Страница: 380 / 594

380
Software • B&R Automation Device Interface (ADI) driver - Control Center
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
Current files with settings for batteries from B&R can be found on the B&R APC620 / PPC700
firmware upgrade disk (starting with V1.16) and can also be updated using these.
10.4.4 Updating UPS battery settings
1) Open the Control Center in the Control Panel .
2) Select UPS tab.
3) Under Battery settings , click on Update . Clicking on "Open" opens a dialog box.
4) Select and open the file containing the battery settings. The "Download" dialog box is
opened.
The transfer can be aborted by clicking on Cancel in the Download dialog box. Cancel is
disabled when the flash memory is being written to.
Information:
To make settings for batteries not from B&R, it is best to make a copy of a file with
battery settings from B&R under a new name and make adjust the settings in this
file for the battery being used.
Information:
• The current UPS firmware version 1.10 does not use charge end voltage, deep
discharge voltage, lifespan and deep discharge cycles.
• Lifespan is only included in version 2 (and higher) of the UPS battery settings
and only valid for B&R UPS batteries at 25°C ambient temperature.
• Deep discharge cycles are only included in version 3 (and higher) of the UPS
battery settings and only valid for B&R UPS batteries.
Information:
If you would like to change the current battery settings on the UPS, they must first
be saved in a file.
Caution!
• The UPS cannot be operated while updating the battery settings.
• If the transfer is interrupted, then the procedure must be repeated until the
battery settings have been updated successfully. Otherwise battery
operation will no longer be possible.