Commissioning
68
Mobile Panel 7100 User's manual 1.51
3 Commissioning
3.1 Installation from a safety perspective
This handheld terminal was developed, manufactured, tested and documented in accordance with ergonomic
guidelines and relevant safety standards. When the guidelines for intended use and safety functionality are ob-
served, there is no danger of damage to property or injury to personnel under normal operating conditions.
The instructions contained in this manual must be observed exactly in every case. Otherwise, hazard sources may
be created or the integrated safety equipment in the handheld terminal may be disabled.
In addition to the safety information in this manual, all applicable occupational safety and accident prevention
guidelines must be observed.
Warning!
The machine manufacturer must configure the handheld control device properly according to the dan-
ger and risk assessment. The following safety aspects must be considered:
- Correct cable length for restricting the work area
- Stop button necessary or permitted
- Sufficient safety category for the respective application
•
The device is only permitted to be operated in good order and condition and in accordance with
the instructions in this manual.
•
The user must possess the required level of training and detailed knowledge of the intended
use as specified in the user's manual.
•
The safety information in the following chapters must be taken into account.
•
Additional important information regarding safety and EMC can be found in chapter "
3.1.1 Proper use of the machine or system
Mobile Panel devices are intended for use in monitoring, configuring and operating machinery. Examples include:
•
Injection molding machines
•
Robots
•
Machine tools
•
Textile machines
•
Printing machines
•
Theater backdrops
•
Etc.
Intended use in normal operating modes, for example:
•
Automatic
Intended use in special semiautomatic or manual special operating modes, for example:
•
Setup
•
Teach-in
•
Test runs
•
Etc.
An enabling device with one or two enable switches and a stop button are available as safety functions.
All safety functions have a dual-circuit design so that up to safety category 4 PL e can be achieved per EN ISO
13849-1:2015.
Safety category 4 PL e per EN ISO 13849-1:2015 is an option for an enabling device with one enable switch, taking
into account the actuation cycles per B
10d
values of the safety component.