System overview
SDL3 Converter User's manual V 2.00 Translation of the original documentation
19
3.5.2.1.3 SDL3 Out interface
The SDL3 Out interface is a female RJ45 connector and
operated with SDL3 transmission technology.
Information:
Hot plugging output devices on the interface for service purposes is supported by the hardware and
graphic drivers of approved operating systems. Recalibration may be required for touch screen de-
vices.
A maximum of 500 mating cycles are specified for this interface.
3.5.2.1.4 LED status indicators
LED status indicators are located on the front of the SDL3 Converter.
Assignment
LED
Color
Status
Explanation
LED status indicator
On
Active SDL communication
Blinking:
On -
50% brightness
Active SDL communication
Faulty or incomplete firmware up-
grade. TBD from what? Link/PC/Con-
verter?
Blinking
No active SDL communication
Status
Yellow
Blinking:
On -
50% brightness
- Off
No active SDL communication
Faulty or incomplete firmware up-
grade. TBD see above
On
The SDL3 connection is established
and OK.
SDL3
Yellow
Off
No active SDL3 connection. And/Or
faulty? TBD
3.5.2.1.5 USB In interface
The USB In interface is a USB 2.0 type B interface that is used to transfer USB data. It must be connected to a
USB interface on the output device (e.g. B&R industrial PC) if DVI operation or SDL operation with a USB cable
was chosen as the transfer method.
For possible transfer methods, see section
"Connection options" on page 9
USB In interface
Standard
USB 2.0
Variant
Type B, female
Low speed (1.5 Mbit/s)
Full speed (12 Mbit/s)
Transfer rate
High speed (480 Mbit/s)
Cable length
Max. 5 m (without hub)
