Commissioning
212
Panel PC 2200 built-in devices User's manual V 1.05 Translation of the original documentation
3.1.3 Installing the Automation Panel 1000 with retaining clips
The Panel PC 2200 with AP1000 panel is installed in the installation cutout using retaining clips. The number of
retaining clips depends on the panel.
The following Automation Panel 1000 panels are installed using retaining clips:
•
5AP1120.0573-000
•
5AP1151.0573-000
•
5AP1120.0702-000
•
5AP1130.0702-000
•
5AP1120.101E-000
•
5AP1130.101E-000
•
5AP1120.1043-000
•
5AP1180.1043-000
•
5AP1120.121E-000
•
5AP1130.121E-000
•
5AP1120.156B-000
•
5AP1130.156C-000
•
5AP1130.185C-000
The thickness of the wall or control cabinet plate must be at least 1 mm and is not permitted to exceed 6 mm.
A 2.5 mm hex screwdriver is needed to tighten and remove the screw on the retaining clips. The maximum tightening
torque of the retaining clips is 1 Nm.
The device must be installed on a flat, clean and burr-free surface since tightening screws on an uneven area can
result in damage to the display or the ingress of dust and water.
Procedure
1. Check whether the supplied mounting screws are screwed into the retaining clips. If this is not the case, then
the mounting screws must be screwed into the retaining clips with a 2.5 mm hex screwdriver. The mounting
screws are only permitted to be screwed in to the point where they do not project beyond the retaining clip.
Retaining clips
Mounting screws
Figure 115: Preparing the retaining clips
2. Insert the device into the front of the prepared, burr-free and flat installation cutout. For the dimensions of the
Fig. 5 "Panel PC 2200 with AP1000 panels with retaining clips - Installation diagram"
