Technical data
Panel PC 2200 built-in devices User's manual V 1.05 Translation of the original documentation
179
Model number
5ACCIF01.FPLS-001
Environmental conditions
Temperature
Operation
-20 to 55°C
Storage
-20 to 60°C
Transport
-20 to 60°C
Relative humidity
Operation
5 to 90%, non-condensing
Storage
5 to 95%, non-condensing
Transport
5 to 95%, non-condensing
Mechanical characteristics
Weight
25 g
Table 168: 5ACCIF01.FPLS-001 - Technical data
1)
Yes, but applies only if all components installed in the complete system have this certification and the complete system bears the corresponding mark.
2)
For additional information, see Automation Help (Communication - POWERLINK - General - Hardware - IF / LS).
2.3.5.5.3.1 POWERLINK interface - Pinout
The POWERLINK interface on the system unit is referred to as "IF option".
POWERLINK
1)2)
Wiring
S/STP (Cat 5e)
Cable length
Max. 100 m (min. Cat 5e)
LED "Status"
On
Off
Green
See status/error LED.
LED "Link"
On
Off
Yellow
Link (a connec-
tion to a POWER-
LINK network exists)
Activity (blinks) (data
is being transferred)
RJ45, female
LED "Status"
1
LED "Link"
Table 169: 5ACCIF01.FPLS-001 - POWERLINK interface
1)
The interfaces, etc. available on the device or module have been numbered for the purpose of clear differentiation. This numbering may deviate from the
numbering used by the respective operating system, however.
2)
In Automation Studio / Automation Runtime, this interface is referred to as IF1.
2.3.5.5.3.2 Serial interface COMA - Pinout
Serial interface COMA on the system unit is referred to as "IF option".
Serial interface COMA
1)2)3)
RS232
Type
RS232, modem supported, not galvanically isolated
UART
16550-compatible, 16 byte FIFO
Transfer rate
Max. 115 kbit/s
Bus length
Max. 15 m
Pin
Pinout
1
DCD
2
DSR
3
RXD
4
RTS
5
TXD
6
CTS
7
DTR
8
RI
9
GND
10
Shield
10-pin, male
1 3 5 7
2 4 6 8 10
9
Table 170: 5ACCIF01.FPLS-001 - Interface COMA
1)
The interfaces, etc. available on the device or module have been numbered for the purpose of clear differentiation. This numbering may deviate from the
numbering used by the respective operating system, however.
2)
This interface (if available) is automatically enabled in BIOS as COMA with default addresses I/O:3F8h and IRQ:4.
3)
In Automation Studio / Automation Runtime, this interface is referred to as IF5.
