Bandit
20
Copyright 3/17
MODEL SA-25
1. Grease cylinder lug pin bushings
:
Grease cylinder lug pin bushings with 1 to 2 shots of
EP-2 Lithium type grease. Wipe off excess grease.
Excessivegreasewillattractdirt.
2. Lubricate all steel friction areas:
:
Lubricate all steel friction areas including , but not
limited to pivoting, hinged, sliding, rotating areas on
the machine (i.e. cutter wheel guard, etc.).
WEEKLY MAINTENANCE
MAINTENANCE
12. Make sure all safety equipment is being worn:
Make sure you are wearing all of your safety
equipment: hard hat, face shield, gloves, eye
protection, ear protection, etc. per ANSI and OSHA
standards.
13.Check the forestry approved door and
window on the skid steer:
Make sure the forestry approved door and window
on the skid steer are in good condition. Repair or
replace as needed.
14.ChecktheLevelIIFallingObjectProtective
Structure (FOPS) cab on the skid steer :
Make sure the FOPS cab on the skid steer is in good
condition. Repair or replace as needed.
15. Follow all daily start up and maintenance
procedures for the skid steer.
Make sure follow all the daily start up and
maintenance procedures for the skid steer, refer to
the manufacturer’s manual.
16. Remember to check EVERYTHING on the
checklist.
DAILY START UP & MAINTENANCE cont.
PAINT CARE
To help keep up the appearance of your Bandit equipment and reduce the possibility of surface rust follow
these steps:
1. The machine should be washed on a regular basis with a non-abrasive mild detergent and then rinsed
thoroughly. Do not pressure wash sensitive areas like: decals, gauges, electronic devices, autofeed
control, etc.
2. If a stone chip, paint scratch, or paint crack occurs - it should be repaired immediately. Simply sand
the edges of the damaged paint area, mask off the surrounding area, and apply primer and paint to
the dry, clean, and warm area. This will keep the damaged area from spreading or getting worse.
3. If you are unable to sand and mask the area, there are containers of primer and paint available. A
small brush can be used to touch up the area.
4. Also, primer and most colors of paint are available in aerosol spray cans to simply spray over the
effected area after it is cleaned, dry, and warmed. This method is not as reliable as the process in
step #2.
It is also reported that some equipment owners polish their machine at least yearly, and keep good mud flaps
on their towing trucks.
Содержание SA-25
Страница 7: ......
Страница 16: ...Bandit 14 Copyright 3 17 MODEL SA 25 RIGHT LEFT BACK FRONT MACHINE OPERATION MACHINE ORIENTATION REFERENCE...
Страница 20: ...Bandit 18 Copyright 3 17 MODEL SA 25 RIGHT LEFT BACK FRONT MAINTENANCE MACHINE ORIENTATION REFERENCE...
Страница 32: ...Bandit 30 Copyright 3 17 MODEL SA 25 SERVICE RECORD SERVICE RECORD DATE DESCRIPTION AMOUNT...