Bandit SA-25, Инструкция по эксплуатации и каталог запасных частей

Страница: 27 / 32

Bandit
25 Copyright 3/17
MODEL SA-25
HYDRAULICS
It is very important after you have operated a new machine for approximately an hour to shut down the machine
and recheck all hydraulic fittings. Retighten as needed.
DO NOT GO NEAR HYDRAULIC LEAKS! High pressure oil easily punctures skin causing serious injury, gangrene,
or death. Avoid burns from fluid. Hot fluid under pressure can cause severe burns. DO NOT use fingers or skin to
check for leaks. Lower load or relieve hydraulic pressure before loosening fittings. Relieve all pressure in the system
before disconnecting the lines, hoses, or performing other work. Use a piece of cardboard to find leaks. Never use
your bare hands. Allow system to cool down to ambient temperature before opening any coolant or hydraulic oil
system.
In cold weather situations let your hydraulic system idle for approximately 15 minutes to allow the system to warm
up to operating temperature.
WARNING
!
DO NOT operate this machine unless all hydraulic control devices operate properly. They must function,
shift and position smoothly and accurately at all times. Faulty controls can cause personal injury!
WARNING
!
After the initial start‑up of the machine and after any replacement of hydraulic components, that fittings
and hoses should be re-checked for leaks and clearances.
DO NOT UNDER ANY CIRCUMSTANCES OVER-SET THESE RELIEF PRESSURES, BECAUSE IT WILL
CAUSE DAMAGE TO COMPONENT PARTS AS WELL AS HYDRAULIC PARTS.
These typical hydraulic flows and settings are with the engine at full RPM. All settings are subject to change!
When returning hydraulic components for warranty make sure to box up all warranted parts to avoid additional
damage while shipping. Do not disassemble any hydraulic components which are to be warranted.
Anything which has been disassembled or tampered with will not be warranted. Items being returned must
be clean. All hydraulic components must have all hosing ports plugged. Failure to plug ports will allow debris
to enter components which will void warranty.
NOTICE
NOTICE
CAUTION
!
NOTICE
For hydraulic trouble shooting refer to the skid steer manufacturer’s manual.
NOTICE
The attachment has three hydraulic hoses on the valve block: one for power, one for return back to tank,
and one for a case drain.
NOTICE
TYPICAL HYDRAULIC FLOWS AND RPM SETTINGS
(Approximate, For Reference Only, Engine At Full RPM)
Needed GPM
(LPM)
Recommended Pressure PSI
(Bar)
Recommended Cutter Wheel
Speed - RPM
30 ‑ 50 High Flow
(113 ‑ 189 High Flow)
3000 - 4100
(207 - 282)
Varies
Contact the nearest dealer
or Bandit Industries, Inc.
for procedures to adjust the
hydraulic pressures.
HYDRAULICS