Bandit 2550, Руководство по эксплуатации, Страница: 46 / 98

Bandit
42
Copyright 4/21
MODELS 2550/2550T MAINTENANCE
Each day before starting your machine these checks must be made:
1. Check the safety decals and engine gauges, replace if damaged.
2. Check, maintain, and service all safety equipment for proper operation.
3. Check entire machine for loose nuts, bolts, and components.
4. Check all guards to make sure they are tight and securely in place.
5. Check the condition of the cutter wheel and teeth pockets.
6. Check the condition of the cutter teeth, pockets, and hardware.
7. Properly torque cutter wheel pocket bolts.
8. Grease cutter wheel arm pivot bushings with 1 to 2 shots.
9. Check and always maintain hydraulic level at 7/8 full.
10. Check all hoses, fittings, lines, and tanks for damage and fluid leaks.
11. Check hydraulic control valves and ensure they operate and shift correctly.
12. Check fuel level. (Running out and repriming is time consuming).
13. Check engine oil, coolant levels, and correct engine speed. Follow ENGINE
MANUFACTURER’S manual specs.
14. Check radiator and debris screen. Clean as necessary. Clean cooling fan and
shroud on air cooled engines.
15. Check oil cooler. Clean as necessary.
16. Check air cleaner, precleaner, and vacuator valve. Clean as necessary.
17. Check the condition of the tires. Fill as needed (2550).
18. Inspect and replace any axle dust caps that are damaged or leaking (Model 2550).
19. Check track tension and condition of the tracks (Model 2550T).
20. Check around the entire machine for any foreign objects, tools, cans, saws, etc.
21. Review all safety procedures on decals, from manual, and from video.
22. Wear all applicable safety equipment: hard hat, face shield, gloves, eye
protection, ear protection, etc.
23. Remember to check EVERYTHING on the checklist.
OK REPAIRED
DAILY START UP & MAINTENANCE CHECK LIST
1. Grease the top and bottom pivot assembly bushings with 1 to 2 shots.
2. Grease steering axle pivot bushings with 1 to 2 shots. (Model 2550)
3. Grease steering bushings with 1 to 2 shots. (Model 2550)
4. Grease cylinder lug pin bushings with 1 to 2 shots.
5. Grease swing out pivot bushings with 1 to 2 shots.
6. Lubricate steel friction areas: pivoting, hinged, sliding, & rotating areas
(i.e. cutter wheel guard, control box doors, etc.)
7. Check the torque on the cutter wheel hydraulic motor coupler bolts:
30 ft-lbs (41 Nm) for machines with 1-3/4” cutter wheel motor shaft (start 3/13)
& 13 ft-lbs (18 Nm) for machines with 1-1/4” cutter wheel motor shaft (pre 3/13).
8. Check and retighten fuel tank and hydraulic tank mount bolts.
9. Check alternator and fan belts on engine, adjust, or replace.
10. Check and retighten wheel lug nuts (Model 2550).
OK REPAIRED
WEEKLY CHECK LIST
Every week these checks must be made:
1. Grease grading blade pivot bushings with 1 to 2 shots.
2. Lubricate cutter wheel engagement lever cable.
3. Check hydraulic function pressures. Set to specified PSI (bar).
MONTHLY CHECK LIST
Every month these checks must be made:
OK REPAIRED