A
B
C
+0.5
+0.0
-2.0
Water temperature calibration
Temperature calibration is used to adjust the water temperature
value from the sonar transducer to match the data from another
temperature sensor. It may be required to correct for localized
influences to the measured temperature.
Calibration range: -9.9° - +9.9°. Default is 0°.
Ú
Note:
Water temperature calibration only appears if the
transducer is temperature capable. Check transducer type
selection if this option should be available.
Transducer type
Transducer type is used for selecting the transducer model
connected to the sonar module. The transducer selected will
determine what frequencies the user can select during sonar
operation. In some transducers with built-in temperature sensors,
the temperature reading may be inaccurate or not available at all if
the wrong transducer is selected. Transducer temperature sensors
are one of two impedances - 5k or 10k. Where both options are
given for the same model transducer, refer to paperwork supplied
with transducer to determine impedance.
StructureScan
This feature is automatically enabled when a TotalScan transducer is
plugged in before the unit has been powered on.
32
Software Setup
| Vulcan Series Installation Manual
Содержание Vulcan Series
Страница 1: ...ENGLISH VulcanSeries Installation Manual bandg com...
Страница 2: ......
Страница 8: ...8 Preface Vulcan Series Installation Manual...
Страница 64: ...988 11099 001 0980...