baltur TBML 80 MC, Инструкция по установке, использованию и обслуживанию

Страница: 88 / 104

• Slightly lower the gas delivery connection (30) and remove the
entire mixing unit in the direction indicated by the arrow.
• Having completed the maintenance work, replace the combustion
head, following in reverse order the operations described above,
after having checked the correct position of ignition and ionisation
electrodes.
DANGER / ATTENTION
When turning on the burner, after connecting the electrode leads
to the terminals, secure them to the gas delivery fitting using a
clamp.
tbml 120 - 160 - 210 - 310
Analyse combustion gases and check that the emission values are
correct at least once a year, in compliance with current law.
• Clean air damper, the air pressure switch with pressure port and
the relevant pipe, if any.
• Check the electrode condition. Replace them, if necessary.
• Clean the photocell. Replace it, if necessary.
• Have the burner and the chimney cleaned by specialised person -
nel (stove repairer); a clean burner is more efficient, lasts longer
and is quieter.
• Check that the fuel filter is clean. Replace it, if necessary.
• Check that all components of the combustion head are in good
condition, have not been deformed and are free from impurities
or deposits deriving from the installation environment and/or from
combustion.
• Analyse combustion gases and check emissions values.
If the combustion head needs to be cleaned, remove the components
following the procedure indicated below:
• Disconnect the diesel hoses (24) from the connectors beneath the
head unit (mind the dripping).
• Unscrew the two screws (12) and turn the burner around the pin
(31) in the hinge.
• After pulling the ignition and ionisation cables (14) out of their
electrodes, unscrew the locking nuts (6) from the mixing unit.
Loosen nut (9) and completely unscrew the fastening screw on
the delivery coupling (19).
24
12
31
26
0002937090
36 / 50
0006160331_202310
ENGLISH