baltur TBG 45 ME, Инструкция по установке, использованию и обслуживанию

Страница: 59 / 72

MAINTENANCE
Analyse combustion gases and check that the emission values are
correct at least once a year, in compliance with current law.
• Check that the fuel filter is clean. Replace it, if necessary.
• Check that all components of the combustion head are in good
condition, have not been deformed and are free from impurities
or deposits deriving from the installation environment and/or from
combustion.
If the combustion head needs to be cleaned, remove the components
following the procedure indicated below:
• Undo the fastening screws (6) and remove the lid (11).
•
Make sure that the mobile plate (23) is fastened by the screw (8).
Once the maintenance operations have been completed, this
will make it possible to return the mixer assembly to the same
position it was in last time it was adjusted.Loosen the screw (24),
which anchors the unit’s forward movement rod to the mobile
plate.
• After having loosened the nut (9) remove the blocking screw (12)
of the mixer unit.
• Completely remove the mixing unit, pulling it out in the direction
shown by arrow (18), after pulling the ignition and ionisation
cables (14) out of their electrodes (figure 4).
Complete maintenance operations, proceed with re-assembly of the
combustion head, following the above instructions in reverse order,
after having checked for the correct position of the ignition and ioni -
sation electrodes (see the COMBUSTION HEAD AND ELECTRODE
DISK DISTANCE REGULATION diagram).
23 / 34
0006081532_202305
ENGLISH