Ballu BOGH-15, Руководство по эксплуатации

Страница: 17 / 24

17
to carry out the procedure for
removing residual air from the
gas cylinder.
• Do not turn on the device
without a reflector cover or when
disassembled.
• The burner and glass tube must
never be completely or partially
covered.
• Do not turn on the device if the
glass bulb is damaged.
• Protect the device from impacts.
• Always place the device on a
sufficiently flat surface (angle of
inclination up to 10 °) to prevent
it from tilting.
• Do not place the unit on an
easily flammable surface (wood,
linoleum, synthetic floors, etc.).
• The heater is equipped with
a safety device that cuts off the
gas supply in case of inclination
by more than 45 °.
• When first turned on, the device
may emit smoke and odor for a
short time.
• After installing the cylinder,
the wick is ignited after a while
(usually 1-2 minutes). This is due
to the fact that there is air in the gas path and it takes some time
to remove it from the gas path.
• Use of the heater at temperatures
below 0°C
• When using a heater in frosty or humid weather, it is
necessary to turn on the flame to the minimum mode, to
warm the glass, after the condensate disappears inside
the flask, gradually increase the height of the flame
column.
• When the gas temperature drops below 0 ° C, the
pressure in the cylinder decreases, and as a result, the
height of the flame column may decrease.
IMPORTANT!
• When the air temperature is
below + 10 ° C, use high-quality
gas, preferably pure propane,
otherwise the flame height may
decrease.
Startup sequence for Ballu BOGH-15
model:
• Ensure that the device is fully assembled;
• Turn the device in the opposite direction from the wind
to avoid blowing out the flame;
• Open the main cover;
• Open the valve on the gas cylinder;
• Press and turn the control knob to the START position.
• Simultaneously press the ignition button until the
ignition flame appears (behind the glass on the side of
the ceramic panel).
• Continue to hold the control knob in the depressed
position for 10-15 seconds after ignition. If the flame goes
out when the knob is released, repeat the previous two
points.
• Turn the control knob to MIN.
• Press the handle and gently turn counterclockwise.
Adjust the height of the flame.
• Close the main cover.
• Enjoy working appliance.