Ballu BOGH-15, Руководство по эксплуатации

Страница: 15 / 24

15
M4x8 stainless steel screws. Attach the visor
cover with the M4x8 screws to the assembled
visor.
Fig.15 - Assembling the visor
• Install a visor on the afterburner, fasten the visor
on stainless steel M6 butterfly nuts (Fig. 16);
Fig.16 - Installing the visor
• Install side covers, fasten them to countersunk
head screws;
• Install the main cover, using magnets on the base
of the device;
Fig.17 - Main and side covers
• Lift the wheel stopper up and move the device
to its destination. Congratulations, you have
completed the build!
butterfly nut M6
Gas connections
• Connect the gas pressure regulator (regulator)
to the cylinder. The thread on the cylinder and the
gearbox is left.
• Tighten the adjuster nut with the wrench to 27.
• Install the cylinder as shown in the pictures 2
and 5.
To assemble the table, you must perform the
following steps:
1. remove the side and main covers from the
product;
2. unscrew the screws (4) securing the upper
profile (1);
3. Get the corner (2) in the slot of the support (3);
4. Insert screws into the holes and tighten them;
5. repeat steps 2-4 for the remaining supports
(Fig. 18);
6. install the stand as shown in Fig. 19, put the
bolts into the holes, but do not tighten them
with nuts;
7. Holding the first stand, install the second stand
as shown in Fig. 20, bolt the holes. Put nuts on
the bolts, but do not tighten them until the end
of the assembly;
main cover
side cover
screw holes
Visor cover
Visor element
Screw M4x8
3
2
1
4
Fig. 18
Fig. 19