Ballu BOGH-15, Руководство по эксплуатации

Страница: 13 / 24

13
the profile on this screw and tighten the screw 2, then
tighten the screw 1;
Fig.10 - Installing the top profiles
• Attach the screws to the afterburner for installation
in the slots of the upper profiles (Fig. 11)
IMPORTANT!
Assembled afterburner with pre-
tightened M4 screws, made of
stainless steel in a quantity of
12 pcs. It is not recommended
to use galvanized screws, since
These screws are not designed for
operation at elevated temperatures.
7. Preparation for work
To build the device, you will need a screwdriver
with a cross (or Phillips) slot;
The assembled afterburner comes 1 assembled
with visor racks. For convenience 2
Assembly disconnect the visor from the
afterburner.
IMPORTANT!
Always use personal protective
equipment - cotton gloves during
assembly and heater installation.
For convenience and safety, the heater should be
assembled by two people.
• Before assembly, remove the protective film
from the parts of the product;
• All necessary screws are pre-tightened into the
seats;
• Before assembly, lock the two wheels of the
instrument by lowering the metal stop down -
This will ensure the stability of the device from
unwanted movements.
Fig.9 - Installing the stoppers
• Install the profiles on the bottom of the pre-
assembled part of the gas heater (Fig. 10). To do this,
make a screw in the middle base, which corresponds
to a slot in the profile (near the center hole). Install
Metal
stoppers
А
medium base
top profile
1
2
А
А
medium base
top profile
1
2
А
Metal
stoppers