Ballu-Biemmedue GE 20, Инструкция по эксплуатации

Страница: 14 / 26

EN
14
FAULTS, CAUSES AND REMEDIES
OBSERVED FAULT CAUSE REMEDY
• Motor does not start, no
ignition
• No electrical current
• Check mains
• Check proper positioning and functioning of
switch
• Check fuse
• Wrong setting of room thermostat or other control
(thermostat and clock)
• Check correct setting of heater control. If
thermostat, make sure selected temperature is
higher than room temperature
• Thermostat or other control defective • Replace control device
• Electrical motor defective • Replace electrical motor
• Electrical motor bearings defective • Replace electrical motor
• Burned out condenser • Replace condenser
• Motor starts, no ignition or
cuts out
• Electric ignitor defective
• Check connection of H.T. Ieads to electrodes and
transformer
• Check electrodes setting (see scheme Fig. 2)
• Check electrodes for cleanliness
• Replace H.T. transformer
• Flame control box defective • Replace control box
• Photocell defective • Clean or replace photocell
• Not enough or no fuel at all at burner
• Check state of motor-pump plastic coupling
• Check fuel line system including fuel filter for
possible leaks
• Clean or replace oil nozzle
• Solenoid defective
• Check electrical connection
• Clean or replace solenoid
• Motor starts, heater emits
smoke
• Not enough combustion air
• Make sure air inlet and outlet are free
• Check setting of combustion air flap
• Clean burner disc
• Too much combustion air • Check setting of combustion air flap
• Fuel contaminated or contains water
• Drain fuel in tank with clean fuel
• Clean or replace oil filter
• Air leaks in fuel circuit • Check fuel line and filter for possible leaks
• Not enough fuel at burner
• Check pump pressure
• Clean or replace fuel nozzle
• Too much fuel at burner
• Check pump pressure
• Replace nozzle
• Heater does not stop • Solenoid defective • Replace solenoid coil or complete solenoid
If heater still not working properly, please revert to nearest authorized dealer.