Baldwin Boxall C2CB4, Руководство по установке

Страница: 50 / 93

Care2
Installation Instructions
Care2 issue 7
41
11. Connect the local Network Connections (see Section 2.4.2
on page 22) to the network card.
12. Repeat steps (1) to (14) for the Slave & all NEP Consoles.
For the SLAVE Console & All NEP Consoles:
1. Ensure the Basic Hardware Commissioning Procedure shown
in Section 4.1 is completed successfully.
2. Ensure the Alternative IP Configuration has been added to
the PC.
3. Connect the Console to the PC using a standard RJ45 lead.
The Ethernet Port is the top connector on the back of the
Console PCB marked with a green dot.
4. Load the IP Configuration spreadsheet that contains the
configuration data for the system (i.e. the spreadsheet
previously saved in step 7 of the Master Console procedure).
5. In “Console Address” select the relevant Console Number
(see Section 5.3.4 on page 69).
6. Complete the Configuration details for the Slave (or NEP)
Console (see Section 5.3.4 on page 69).
7. Save the spreadsheet (identifiable as the relevant Slave or
NEP console) to a known location as this contains the
configuration data for all the outstations and the settings
specific to the Relevant Console .
8. Select the “Connect and SAVE ALL Config Data to Console”
(see Section 5.3.4 on page 69).
9. Repeat steps (1) to (6) for the Slave & all NEP Consoles.
10. Clear Device Assignments (see Section 7.6 on page 81).
Note: Perform a System Reset on the MASTER Control Panel after all
other panels are configured and connected.
N
OTE
: Depending on the age of the PC, a "Cross-over" RJ45 lead may
be required instead of a standard RJ45 lead.
N
OTE
: The saved Spreadhseet MUST contain valid configuration data
for the complete system.
www.acornfiresecurity.com
www.acornfiresecurity.com