Baldor Global TEFC Series, Инструкция по установке и эксплуатации

Страница: 8 / 37

Section 1
General Information
General Information 1-3 MN409
Safety Notice Continued
WARNING: Use of an air jet may cause flying debris and generate particulate matter. Wear suitable skin,
eye and respiratory protection. Failure to observe this precaution may result in bodily injury.
WARNING: Space Heaters operate at line voltage. Disconnect power to space heaters before performing
maintenance work on motor. Failure to observe this precaution could result in severe bodily
injury or loss of life.
WARNING: Thermostat contacts automatically reset when the motor has slightly cooled down. To prevent
injury or damage, the control circuit should be designed so that automatic starting of the motor
is not possible when the thermostat resets.
Caution: To avoid damage to the windings do not use air pressures greater than 30 psi (200 kPa). Avoid
directing the air in such a way that the dirt will be blown into inner crevices.
Caution: To prevent premature equipment failure or damage, only qualified maintenance personnel
should perform maintenance.
Caution: Do not over − lubricate motor as this may cause premature bearing failure.
Caution: Over − lubricating can cause excessive bearing temperatures, premature lubrication breakdown
and bearing failure.
Caution: Do not lift the motor and its driven load by the motor lifting hardware. The motor lifting
hardware is adequate for lifting only the motor. Disconnect the load from the motor shaft
before moving the motor.
Caution: If eye bolts are used for lifting a motor, be sure they are securely tightened. The lifting
direction should not exceed a 20 ° angle from the shank of the eye bolt or lifting lug. Excessive
lifting angles can cause damage.
Caution: To prevent equipment damage, be sure that the electrical service is not capable of delivering
more than the maximum motor rated amps listed on the rating plate.
Caution: If a HI POT test (High Potential Insulation test) must be performed, follow the precautions and
procedure in NEMA MG1 and MG2 standards to avoid equipment damage.
Caution: Sleeve bearing motors are shipped without oil. To avoid motor damage, do not rotate the shaft
until you have filled the oil reservoirs to the proper level with recommended lubricant.
Caution: To avoid damage to motor bearings, grease must be kept free of dirt. For an extremely dirty
environment, contact your Baldor distributor or an authorized Baldor Service Center for
additional information.
Caution: Do not use solvents containing trichloroethane to clean interior or exterior of motor. Damage
may occur to paint and insulation systems.
If you have any questions or are uncertain about any statement or procedure, or if you require
additional information please contact your Baldor distributor or an Authorized Baldor Service Center.
Receiving
Each Baldor Electric Motor is thoroughly tested at the factory and carefully packaged for shipment.
When you receive your motor, there are several things you should do immediately.
Do not unpack until ready for use.
1. Observe the condition of the shipping container and report any damage immediately to the
commercial carrier that delivered your motor.
2. Verify that the part number of the motor you received is the same as the part number listed on your
purchase order.
This Manual:http://www.manuallib.com/baldor/mn409-large-ac-motors-handbook.html