Balcrank 3331-018, Руководство по эксплуатации, установке, обслуживанию и ремонту

Страница: 18 / 26

Changing the Scale Factor changes the accuracy of the meter, potentially causing it to
overfill or under fill. This has the potential to cause a mechanical breakdown.
Change Scale Factor
Scale Factor Digits
Scale Factor Display
1. Press the button to advance through the
Scale Factor digits.
2. Press the button to change the selected
number.
NOTE: All digits can be scrolled between 0 and 9 except
the first. It can only be scrolled from 0 to 1 or from 1 to 0.
3. Press the button to advance to the next number in Scale Factor.
4. Repeat steps 2 and 3 for all five digits in Scale Factor.
5. If no other changes are necessary, refer to the Save Changes section in the manual.
EPM (MANUAL) Mode enable/disable
To disable or enable the EPM mode of the meter:
1. Press the button to advance to the AUTO icon on the display, there will be no
other icons flashing on the display.
2. Then press the button to toggle on and off the AUTO icon. When the icon is
turned on the meter can be put in EPM mode through the special key sequence on the
meter keypad. When the AUTO icon is turned off the key sequence is disabled and the
meter cannot be put in EPM mode.
Save Changes
To Save Changes and exit the programming mode:
1. Push and hold at the same time the and buttons.
2. The display will flash 3 times and go blank.
3. Press the button and the display will turn back on.
Verify Changes
1. Verify Unit of Measure is correct.
2. Push and hold the button and button together, to verify that the Scale
Factor is correct.
14