Bajaj Auto Legend 00300728, Руководство по обслуживанию станции, Страница: 19 / 66

15
(16 ) Replacement Parts
When there is a replacement instruction, replace
these parts with new ones every time they are
removed. These replacement parts will be
damaged or lost their original function once
removed.
(17 ) Inspection
When parts have been disassembled, visually
inspect these parts for the following conditions or
other damage If there is any doubt as to the
condition of them, replace them with new ones.
Abrasion Crack
Hardening Warp
Bent Dent
Scratch Wear
Colour change Deterioration
Seizure
(18 ) Service Data
Numbers of service data in this text have following
meanings:
“Standards” : Show dimensions or performances
which brand-new parts or systems have.
“Service limits”: Indicate the usable limits. If the
measurement shows excessive wear or
deteriorated performance, replace the damaged
parts.
(14 ) Lubrication
Engine wear is generally at its maximum while the
engine is warming up and before all the rubbing
surfaces have an adequate lubricative film. During
assembly, oil or grease (whichever is more
suitable) should be applied to any rubbing surface
which has lost its lubricative film. Old grease and
dirty oil should be cleaned off. Deteriorated grease
has lost its lubricative quality and may contain
abrasive foreign particles.
Don’t use just any oil or grease. Some oils and
greases in particular should be used only in certain
applications and may be harmful if used in an
application for which they are not intended. This
manual makes reference to molybdenum disulfide
grease (MoS
2
) in the assembly of certain engine
and chassis parts. Always check manufacturer
recommendations before using such special
lubricants.
(15 ) Electrical Wires
All the electrical wires are either single-colour or
two-colour and, with only a few exceptions, must
be connected to wires of the same colour. On any
of the two-colour wires there is a greater amount
of one colour and a lesser amount of a second
colour, so a two-colour wire is identified by first the
primary colour and then the secondary colour. For
example, a yellow wire with thin red stripes is
referred to as a “yellow/red” wire; it would be a
‘’red/yellow” wire if the colours were reversed to
make red the main colour.
Wire (cross-section) Name of Wire Color
Red
Wire strands Yellow/red
Yellow
Red