Bajaj Auto Legend 00300728, Руководство по обслуживанию станции, Страница: 16 / 66

12
Screw for head lamp adjustment
STEERING :
Steering play :
If the steering is too tight, it will be difficult to turn the
handlebar quickly, the vehicle may pull to one side and the
steering stem bearings may become damaged. If the
steering is too loose, the handlebar will vibrate and the
vehicle will be unstable and difficult to steer in a straight
line.
Inspection :
l
Raise the front wheel off the ground.
l
From the straight forward position of the handle bar
slowly push the handlebar to either side.
l
If the handle bar to turn by the action of gravity and
continues moving until its stopper on L.H.and R.H.
side, the steering is not too tight.
l
If the handle bar does not begin to turn by the action
of gravity, the steering is too tight necessitating
adjustment.
l
Squat in front of the vehicle and grasp the lower ends
of the front fork. Push and pull the fork end back and
forth.
l
If the play is felt the steering is loose, necessitating
adjustment.
Adjustment :
l
Remove handle bar covers.
l
Loosen Handle bar bolt & lift up slightly.
l
Loosen the upper lock ring nut.
l
If the steering is too tight, loosen the lock nut a
fraction of turn; if the steering is too loose, tighten the
locknut a fraction of turn.
Brake/Tail light, rear blinkers bulb replacement :
For replacing Tail/stop bulb or rear blinkers bulb, remove
2 screws for lens, take out lens & replace bulb.
Removal of screws for lens
Front blinker bulb replacement :
l
Remove 2 mounting screws for nose grill and take out
nose grill.
l
Remove 2 mounting screws for blinker and take out
blinker assly.
l
Take out holder & replace the bulb.
HEAD LIGHT BEAM ALIGNMENT
The headlight beam can be adjusted vertically and
horizontally. If adjusted too low, neither low nor high beam
will illuminate the road adequately. If adjusted too high,
the high beam will fail to illuminate the road.
l
Keep the vehicle off the stand facing a wall.
l
Inflate both front and rear tyres to specified inflation
pressure.
l
There should be sufficient darkness.
l
Keep the vehicle at a distance of 5 meter/16.4 ft from
a wall as shown in figure.
l
Start the vehicle. Switch ON the Headlight high beam
and then lower beam.
l
Check the beam pattern on the wall.
l
For correct pattern of High beam & low beam, a screw
is provided below Head lamp assly. Loose this screw
before carrying out adjustment. Pressing Head light
assly at the top shifts the pattern up and pressing
Head light assly at the bottom, shifts the pattern down.
l
The High beam pattern should be as shown in figure
and it should be 1 meter/3.28 ft. above the ground.
l
The Low beam pattern should be set 5 cm below the
HV point as shown in the figure.
SCREEN
1M/3.28 FT
5 M/16.4 FT
VEHICLE OFF THE STAND
1M/3.28 FT
HV
H
V
Hi Beam pattern
HV
2M/6.56 FT
5CM
15°
V
Low Beam pattern
HV
2M/6.56 FT