Bailey infi 90 NIMP01, Инструкция

Страница: 39 / 52

INTRODUCTION
I-E96-401A B - 1
APPENDIX B - IMMFP03 MULTI-FUNCTION PROCESSOR
INTRODUCTION
The IMMFP03 Multi-Function Processor Module has four con-
figurable dipswitches, one socket and five jumpers. Each
dipswitch has eight positions. Figure
B-1 shows the location of
dipswitches and jumpers on the multi-function processor
(MFP) circuit board. Dipswitch UUB0 sets the module address,
bus speed and operation mode (normal/diagnostic). Dipswitch
UMB1 sets module options and enables special operations.
Tables
B-1 through B-6 list the dipswitch setting descriptions.
The HW SETUP socket defines the number of SRAM banks
installed and selects wait states for ROM, NVRAM and SRAM.
Table
B-7 shows the jumper settings for the HW SETUP socket.
Table B-8 shows the jumper settings. Jumpers J1, J2, J4 and
J5 define module functions and operation. Their settings:
•
Determine if the diagnostic RS-232-C ports operate as DCE
or DTE.
•
Define the density of the SRAM device installed on the
module.
•
Enable the machine fault timer (MFT).
•
Disengage -30 VDC from the module when installing it in a
module mounting unit (MMU) that uses -30 VDC.
Figure B-1. IMMFP03 Module Layout
T00200A
CR17
SW6
J4
J1
P5
P4
UUB0 UMB1 LMB2 LLB3
J2
P3
P1
P2
2MBIT
1MBIT 4MBIT
OPTION
SWITCH
SW4
SCSI
SWITCH
SW3
BAUD
RATE
SWITCH
SW1
DIAGNOSTICS
SWITCH
SW2
1 2 3 4
OPEN
5 6 7 8 1 2 3 4
OPEN
5 6 7 8 1 2 3 4
OPEN
5 6 7 8 1 2 3 4
OPEN
5 6 7 8
HW SETUP
1
16
2
15
3
14
4
13
5
12
6
11
7
10
8
9
30V
MODB
J5