19
19
ADJUSTMENTS
Check all mounting screws and bolts to see that they are tight.
SQUARING THE FENCE
Periodically the wood fence will have to be
squared with the mounting surface and
adjusted parallel to each other.
To correct, do the following:
1. Check the two mounting screws A, Figure
6 holding the fence assembly to the table
and make sure they are tight.
2. Check the six countersink flat head bolts
B that secure the wooden fences and
make sure they are tight.
BELT ADJUSTMENT
Check the drive belt to insure that the sheaves are accurately aligned. If alignment is required,
loosen the set screw in the motor sheave and reposition the sheave on the motor shaft.
SPEED CHANGE
The shaper may be operated at 3600 or 5100 or
8000 or 10,000 RPM. To change the spindle. speed,
loosen the lock handle shown in Figure 7 ,and pivot
the motor assembly toward the spindle. Reposition
the belt to the desired speed step and retention the
belt.
CAUTION:
When changing tools, adjusting the drive belt, or doing
cleanup and maintenance, always turn the machine off and unplug the machine from
its power source.
Содержание SS-3528
