20
20
CHANGING SPINDLE
The shaper is supplied with both 3/4” and 1’ and 1 1/4”
spindle assemblies. These assemblies are locked in a
tapered seat with a draw bar and nut. To change
spindles, place one wrench on the flats on the top of the
spindle and another wrench on the draw bar nut
underneath the spindle drive sheave as shown in Figure
8. Turn the nut about two turns and tap upward lightly
with a wood block to break the spindle loose from the
taper. Finish removing the nut and lift out the spindle.
CHANGING CUTTERS
Each size spindle is supplied with a safety lock nut with left
hand threads located above the larger spindle nut as
shown in Figure 9. To mount or change cutters, first
remove the safety lock nut. Remove the spindle nut by
placing one wrench on the spindle nut and another wrench
on the flats on top of the spindle. Always replace the safety
lock before operating shaper.
Tool changing must be done with the utmost care keeping
in mind the following:
Cutters, collars, and spacers mounted on the spindle
shaft must have a perfect fit with no room for movement
or play between parts.
Holes and counter-bores of cutters, collars, and spacers must be perfectly shaped without
rust, dings, nicks or other flaws.
Clean all cutters, collars, and spacers before installing them on the spindle.
Always mount the cutter as low as possible on the spindle.
Make sure all parts on the spindle are locked in position before starting the shaper.
Содержание SS-3528
