23
23
Blade Gap Adjusting Handle
The process of shearing can produce a shear edge
burr. This burr can be minimized by adjusting the
blade gap to the thickness of material being
sheared and by keeping the blades sharp. The gap
distance (fig.12) is changed by positioning the
handle up or down as in (fig. 11). Pull out the spring
loaded pin and rotate 90°. Move the handle over
the size of the material you will be shearing and
release the pin. The correct blade gap is now set.
This gap must be held
parallel
along the full length
of the blade. This is accomplished by precisely
rotating the two lower eccentric bearings the same
distance on each end of the machine. Note the
chain drives on both ends and the shaft connecting
them together (fig. 13).
Shown with chain
Guard removed
Gap
figure 12
figure 13
Upper blade
Lower blade
figure 11
Pin
Содержание SH-8008HD
