Baileigh SH-8008HD, Руководство оператора

Страница: 27 / 60

24
24
Manual Back Gauge
The back gauge is used to adjust the setting of the back gauge dimension to control the size
of the pieces dropping behind the blades.
The manual back gauge assembly will need to be attached to the back end of the shear.
There are two blocks with holes in them for this purpose. Move the back gauge into position
using a suitable lifting device. Slide the shafts into the blocks until they bottom out. If
necessary, gently tap them in from side to side. Once in place, secure with the bolts and
washers shown in (fig. 14). To use the back gauge, loosen the two adjustable handles which
are attached to the guide blocks. By turning the hand wheel you will be able to move the stop
angle into position. The scale and indicator allow you to keep track of that position. Tighten
the handles.
CAUTION:
When handling large piece parts, you may require
assistance in handling the piece as it exits the blades. Failure to adequately
support the piece part may result in the piece falling and causing bodily injury.
figure 14
figure 15
figure 16
Adjustable handles