23
23
6. In a coordinated fashion, both operators should
rotate the handlebar to begin the cut. The shearing
action begins at the left side of the piece part and
continues to the right until the cut is complete.
a. The pressure plate (
#63
) should make
contact with the sheet before the blade (
#46
)
does. If it does not, adjust the two hex bolts
(
#17
) on the pressure plate brackets to lower
the pressure plate. When fully open the gap
should not exceed 0.125” (3.175mm).
7. Carefully lift the cut piece from the rear of the
machine if it does not fall to the tabletop or floor on
its own.
46
63
17
Shear Blade
Hold down
Side Guide
Work Apron
Spring Loaded
Upper
Shear Blade
Lower
Содержание SBR-5220
