Baileigh Industrial DP-1400VS, Руководство оператора

Страница: 29 / 48

26
26
Safety guard must be properly positioned with the
limit switch roller in the detent of the adjustable ring
or the machine will not run. The electrical enclosure
cover must be closed and locked, and the
emergency stop button must be reset by turning
clockwise (cw).
1. Load and secure the piece part to the table.
2. Secure drill or tapping bit in the chuck.
3. Unlock the table, set to desired position, and
lock.
4. Adjust the safety guard as necessary.
5. To set the depth stop, use the down-feed
handle (A), to bring the tip of the drill or tapping
bit to the surface of the work piece (B) and hold
this position. (This is zero position.)
6. Rotate knob (C) to set the drill depth on the scale with indicator (D).
7. Release the down feed handle and allow the quill to raise to the full
up position.
8. Select either the drilling or tapping mode with selector switch.
9. Press green start button to begin spindle rotation.
10. Spindle speed is set with knob speed control knob and can be read
on the digital indicator.
11. Turn ON the coolant using the paddle switch on the face of the drill head.
12. Use the quill feed handle to start drilling or tapping.
13. While tapping, the spindle will reverse rotation when the depth stop is reached. The quill will
also the reverse direction to lift the tap out of the work piece.
Note: In general, use low speeds for tapping. By tapping at high RPM there is a
danger of damage to the piece part or the tooling. While tapping, the tool can be backed out at
any time by reversing the feed handle.
14. At the end of the operation, press the red stop button to turn OFF the machine.
IMPORTANT: In the event of incorrect operation or dangerous conditions, the
machine can be stopped immediately by pressing the E-STOP button. Twist the button
clockwise (cw) to reset.
A
D
C
B