Baileigh Industrial BS-210M, Руководство оператора

Страница: 35 / 60

32
32
Adjusting the Blade Guide
1. Disconnect Power From the Saw.
2. Release the extension bar for the blade guide block by
turning clamp handle (AC) counterclockwise (ccw) to
loosen the clamping block (AD).
3. Hold the revolving handle (AB) and slide the blade
guide block as close as possible to the piece part
without interfering with the cut.
4. Tighten clamp handle (AC) clockwise (cw).
Blade Guide Bearing Adjustment
ATTENTION: This is the most important adjustment on your saw. It is impossible to get
satisfactory work from your saw if the blade guides are not properly adjusted. This saw has
been adjusted and power tested before leaving the factory to insure proper setting. If the guides
do get out of adjustment, it is extremely important to re-adjust immediately. An improperly
adjusted blade will not cut straight and serious blade damage may result. It is always best to try
a new blade to see if this will correct poor cutting before beginning to adjust the blade guide
bearings. If the blade becomes dull on one side and not the other, for example, it will begin
cutting crooked. A blade change will correct this problem; the guide adjustment will not. If a new
blade does not correct the problem, check the clearance between the blade and guides.
Clearance should be from just touch
ing to .001”.
1. Disconnect Power From the Saw.
2. Remove guard (AE) for access to the bearing.
3. Loosen nut (AF) on the eccentric bearing.
4. Turn adjusting nut (AG) clockwise (cw) to move the
bearing away from the blade.
5. Turn the adjusting nut counterclockwise (ccw) to move
the bearing closer to the blade.
6. After adjustment, retighten nut (AF) and replace guard
(AE).
AF
AG
AE
AB
AC
AD