Baileigh Industrial BS-210M, Руководство оператора

Страница: 31 / 60

28
28
In the event of incorrect operation or dangerous
condition, press the
E-STOP button (D) to
immediately shut off all functions of the saw. Twist
the emergency stop button clockwise (cw) to reset.
Note: Resetting the E-STOP button
will not start the machine.
Auto Mode Operation
1. Close the handle on the hydraulic ball valve (I)
by turning it counterclockwise (ccw).
2. Turn the flow control knob (AH) clockwise (cw) to
shut off the hydraulic flow. This will prevent the saw bow from dropping when the ball valve is
opened.
3. Increase the bow weight. Rotate the wing nut (AI) counterclockwise (ccw) to decrease the
tension on the spring.
4. Load piece part and clamp securely.
5. Turn the main switch (A
) to “ON”. Check to see that indicator light (B) is lit.
6. Set the blade speed with control knob (E).
7. Set switch (G) clockwise (cw) to auto mode for hydraulic cylinder operation.
8. Press the green start button (C). The saw motor and the coolant pump motor should both
start.
9. Open the ball valve (I) clockwise (cw).
10. Turn the flow control knob (AH) clockwise (cw) to slow down the descent or
counterclockwise (ccw) to speed it up.
11. When saw bow reaches bottom limit, micro-switch (M) is actuated and shuts off the saw and
pump motors.
12. Grasp the control handle and lift the saw bow to a height slightly above the piece part to
minimize the next cut entry time.
13. Close ball valve (I).
14. Unclamp and reset the piece part to continue the next cutting cycle.
E
F G
A
D
C B